Installation Guide

What type of Wi-Fi do I need ?
Like many devices, LIFX lights connect to the 2.4Ghz
band of Wi-Fi, not 5Ghz. If you have more than one
available network on your router, this could mean you are
connected to 5Ghz and need to try your other network.
Almost all Wi-Fi routers will have a 2.4 GHz band so if you
only have one network you will likely be on the right one
to get started.
How do I reset a light to factory settings ?
Turn the light o and on at the switch 5 times, about one
switch a second (not too fast). The lights will cycle through
four colors or whites and stop on white when the reset
has been successful. This is how you would remove a light
from a network to then add it to a new one.
I’ve set up a new network / changed my password, how
do I re-connect my lights ?
If you’ve changed your Wi-Fi password or set up a new
router with a new password, you will need to reset your
lights and connect them through the app as you did the
first time you connected them. This is so you can assign
the new, correct password for the security of each device.
How do I connect other devices and services like Voice
control or IFTTT ?
This can vary depending on the service you’d like to use.
You can find out about major partner products LIFX work
well with at LIFX.com. For advice on connecting services
you can find instructions for these at go.LIFX.com
FAQS
Connectivity, setup and
troubleshooting
Need more help?
Visit the LIFX Help Center at support.lifx.com