Full Product Manual

below its optimal capacity. For optimal
performance it is recommended that LIFX
bulbs be fitted into fixtures that provide
sucient air flow through and around
the bulb. It is recommended that the LIFX
bulb be installed away from other devices
designed to receive or transmit radio
signals. It is recommended LIFX bulb/s
be installed and operated at a minimum
distance of 30 cm from the body. For
lamps with a weight significantly higher
than that of lamps for which they are a
replacement, attention should be drawn
to the fact that the increased weight may
reduce the mechanical stability of certain
luminaires and may impair contact
making and lamp retention.
Interference
LIFX has been designed to minimise
interference with other radio, broadcast
or receiving devices. The manufacturer
is not responsible for any interference
caused as a result of modifications to
the product or by failure to adhere to
the recommendations in this document
and at support.lifx.com. This device
generates radio frequency energy and,
if not installed in accordance with the
“recommended installation requirements”
may cause harmful interference to
radio communication devices. If the
device is causing radio interference it is
recommended that the user try:
a. relocating the device to a dierent place;
b. adjust the antenna on the receiving
device;
c. consult a technician experienced in radio
interference.
Notices
• This device is not intended for use with
emergency exits
• Only use the control provided with or
specified by these instructions to control
this lamp. This lamp will not operate
properly when connected to a standard
(incandescent) dimmer or dimming
control.
LIFX is not designed for use in:
• Excessively hot environments (e.g. close
to ovens, radiators, heaters, etc.)
• Regions or countries other than that in
which the product was intended for
• Outdoor and wet areas, except where
the LIFX Product specifies that it is for
both Indoor and Outdoor use.
When using LIFX
• To avoid risk of shock, always make
sure the product is unplugged from
the electrical outlet before assembling,
disassembling, installing, relocating,
servicing or cleaning it.
• Do not open device, as this will void the
warranty
• If cleaning the product, use a soft dry
cloth, do not use cleaning agents
Limited Warranty