Installation Instructions

5
www.lightengineering.net
4 - SENSOR PROGRAMMING
This procedure is used to programme a channel in order to then associate it with a compatible receiver.
Access to the receiver is required to carry out the following procedure.
STEP1
Activate the receiver on which you want to use the tran-
smitter in “multifunctional remote control radio program-
ming” (see receiver manual).
STEP2
With the help of a paper clip make a
short press on the button in the back
of the sensor (the led of the sensor
turn on green)
STEP2
With the help of a paper clip make a
short press on the button in the back
of the sensor (the led of the sensor
flashes 3 times)
SHORT
PRESS
SHORT
PRESS
LED TURNS ON
GREEN
LED FLASHES
3 TIMES