Installation Instructions

5 - SENSOR SETTING
The sensor is supplied with pre-set parameters:
DETECTION AREA= max ; BRIGHTNESS THRESHOLD= off ; TIMED ON= 5 minutes.
These parameters can be modify with following procedure:
STEP1
With the help of a paper clip press and hold the button
on the back of the sensor:
the led turns on and cyclically changes color
STEP3a
Release the button when the led is
red to set the detection area of the
sensor
STEP5a
Make a short press on the button
on the back of the sensor during
the flash that correspond to the
desired function
(default= n°1)
STEP5b
Make a short press on the button
on the back of the sensor during
the flash that correspond to the
desired function
(default= n°1)
STEP5c
Make a short press on the button
on the back of the sensor during
the flash that correspond to the
desired function
(default= n°3)
STEP3b
Release the button when the led is
green to set the brightness thre-
shold of the sensor
STEP3c
Release the button when the led is
yellow to set the timed on off
the light
STEP2
Release the button when the led is on the color corresponding to the function that you want to modify:
LONG
PRESS
LED CHANGE
COLOR
CYCLICALLY
RED=
DETECTION AREA
GREEN=
LIGHT SENSOR
YELLOW=
TIMED OFF
RELEASE
THE BUTTON
RELEASE
THE BUTTON
RELEASE
THE BUTTON
LED RED LED GREEN LED YELLOW
N° Function
1 No threshold (the sensor
always turns on the light)
2 Level 2
3 Level 3
4 Level 4
5 Level 5
6 Level 6
7 Level 7
8
High level (the light turns on
only when in deep darkness)
N° Function
1 Max detection
area
2 Level 2
3 Level 3
4 Level 4
5 Min
detection area
N° Function
1 5 seconds
2 1 minute
3 5 minutes
4 20 minutes
5 30 minutes
6 1 hour
7 2 hours
8 4 hours