Instructions / Assembly

Please Read This Before

You Start

The Motion-Activated Porch Light uses both a MOTION sensor and a

PHOTO sensor. The photo sensor prevents the light from being activated

during daylight hours or when other light sources are present.

When batteries are installed the light will come on and the electronic

circuitry will set. The light will turn off when the process has completed.

If the light does not turn off after battery installation and initial circuitry

set, we recommend testing the unit by placing it in dark room away from

any possible heat and light sources. If operating normally, the light should

turn off after 30-45 seconds if no motion is present. Light should turn back

on when motion is again detected. If light does not function properly

please see Troubleshooting below or contact us for further assistance.

Manual Operation

This light operates by sensor only. It does not have an on/off switch.

However the light may be turned off by rotating the sensor toward the wall

(mounting surface) so that it is covered by the light casing. The battery door

will be visible, but the sensor will not. In this position, the sensor will not

be able to detect motion and will not activate the light. Return to normal

position when operation by sensor is desired.

Troubleshooting

No mounting plate

Remove the mounting plate as per the diagram in the instructions.

Light will not turn off

Test the light as instructed above.

Light will not turn on

Check to make certain that your batteries are fresh.

Check the alignment (polarity) of the batteries.

Check to make certain that the battery holder has been properly installed

and the contacts properly aligned.

Moisture in the battery case

Check to make certain that the battery door has been securely closed to

ensure a tight t against the rubber seal.

Fulcrum Products, Inc. • info@fulcrumproducts.com • 503-274-1227

PLEASE READ THE ENCLOSED INSTRUCTIONS THOROUGHLY

BEFORE USING THIS PRODUCT.

PAGE 1
Please Read This Before You Start The Motion-Activated Porch Light uses both a MOTION sensor and a PHOTO sensor. The photo sensor prevents the light from being activated during daylight hours or when other light sources are present. When batteries are installed the light will come on and the electronic circuitry will set. The light will turn off when the process has completed.
PAGE 2
Lea esto antes de empezar la instalación. El foco activado por movimiento tiene dos sensores: uno que identifica movimiento y otro que identifica luz. El sensor para la luz impide que el foco se active durante el día o cuando haya otras luces encendidas en la área. Después de instalar las pilas, se encenderá el foco y se establecerá el circuito eléctrico. Se apagará el foco cuando termine el proceso.
PAGE 3
À lire avant de commencer La lampe de porche activée par le mouvement utilise à la fois un détecteur de MOUVEMENT et une cellule PHOTOÉLECTRIQUE. La cellule photoélectrique empêche la lampe d’être mise en marche durant la journée ou lorsque d’autres sources de lumière sont présentes. Lorsque des piles sont installées, la lampe s’allumera et le circuit électronique sera activé. La lampe s’éteindra lorsque le processus sera terminé.