Owner's Manual Underwater Camera BLUEFIN HC7

Camera Preparation

1. Install a fully charged Sony “InfoLithium” H series battery pack (NP-FH100 recommended).

2. Install a HD DVC tape into your camcorder.

3. If still images are desired, install a Memory Stick Duo. Press the Flash button on the

right side of the camcorder to disable the camcorder’s built-in flash preventing the flash

from reflecting back into the camcorder’s lens.

4. Open the camcorder’s LCD screen. Rotate the LCD screen 180 degrees so the LCD

screen is facing away from the camcorder. Close the LCD screen against the camcorder

body so the screen is facing outward.

5. Enter the camera’s MENU and confirm or change the following settings. Scroll to the

STANDARD SET sub-menu and select it.

a. Change the Remote Control to the ON position (Refer Fig. 1).

b. Change the REC LAMP to the OFF position (Refer Fig. 2).

c. Change the DISP OUTPUT to the V-OUT/PANEL position (Refer Fig. 3).

If you’re using a monitor, this will display the camcorders icons, remaining battery

time, remaining tape time and other information in the Light & Motion monitor.

(Fig. 1) (Fig. 2)

(Fig. 3)