2 Light ‘nn’ Easy er. Manual | digs 3 High-temperature Steam WE for Deep Cleaning & Ready to Use in 20 Seconds ® Power Cord 20Ft Thank you very reach fo purchasing cur new isn nap, be sirs to read the instructions canonically before using. Fla ass keep this guidance or easy reference.
1 PARTS AND FEATURES Ergonomic Handy i Quick Release Cord Wrap Cleaning Pad(3 pieces) } JS Lower Handle Tubs Filling Flask / Pump Actuator Lower Cord Wrap & i Agree thy Tank Cag { oft Power indicator Light } Water Tank ef Steam Mop Base Bap Head — Read all instructions before assembly and use of the appliance. Safeguard these instructions for future reference.
[| Assembling A IMPORTANT Make sure that the unit is unplugged before the microfiber cleaning pad is attached. Always attach the microfiber cleaning pad to the mop head, or you Fry scratch your floor. 1. Verify all the listed parts are included. 2. Slide the extension handle into the lower handle tube(the short tubs), Push the two tubes together, a sound of click means they are assembled successfully, (fig 1} 3.
. Place the microfiber cleaning pad underneath the mop head, with quick fastener strips facing up. Press the mop to the pad to attach it (fig.3) An IMPORTANT Be fora filling up the tank, make sure your steam mop is unplugged. 1. Turnover the cap to fill the water tank. Rotate the tank cap counterclockwise to open. 2. Use the filling flask and funnel to fll the tank with water to the "MAX fil line. (ig4} 3. Replace the water tank cap by rotating it clockwise, Tips 1.
I Operation NOTICED: For the first use or long term idle, it may take one more minutes for creating steam because of the pumping procedure, Get it started by pumping the handle a few times. If you have waited a few minutes and vou still do not see any steam, reference the troubleshooting section. An IMPORTANT Your stair mop needs water to make steam! Never use your steam mop without water in the tank. Sweep or vacuum your floors before using your steam mop.
1 Care and Storage Aa IMPORTANT The cleaning pad may be very hot from the steam after use. Use caution when removing it. Let the unit cool for 3-5 minutes first before removing. 1. After using the steam mop, unplug the cord from the outlet, place the mop into the upright position, and let the unit cool 3.5 minutes, 2, Carefully separate microfiber cleaning pad from the steam mop, avoiding contact with the hot pad or dirt, (figs) 3, Eternally the water tank before storage.
Model Voltage Frequency Power | Water Tank Capacity TEL BAND 120v&0Hz 1150W 220ml Tips tis subject to change without notice due to continuing design and quality improvements, For cleaning performance, please change the microfiber cleaning pad when tis needed, i Troubleshooting Guide Problem Possible Reasons & Solutions Steam Mop 1 Make sire the power cord of the stern map has been connected. will not warm on. 2. Check your fuse or breaker. Steam Mop 1.
{ Safety Instructions For Household {se Only BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED WHEN USING THE STEAM MOP, READ ALL INSTRUCTIONS BEFORE USAGE. 1. Use as described in this manual, 2, Use only manufacture's recommended accessories. 3. Bo not use outdoors, 4. Da not wale the appliance unattended when plugged in. Always unplug the power cord from the electrical outlet when not In use and before serving. 5. Ba riot allow the appliance ta be used as a tay.
wtb Be pay =F STEAM MOR XI AC TIN (TANGSHAN) INDUSTRIAL CO. LTD.
