User's Manual

ManualsBrandsLightcomm Technology ManualsComputers & Accessories8 Inch Wi-Fi Android Tablet

Insignia NS-16AT08 8" WiFi Android™

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne

doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

(i)the device for operation in the band 5150-5250MHZ is only for indoor use to reduce the potential

for harmful interference to co-channel mobile satellite systems;

(i) l'appar

eil pour fonctionner dans la bande 5150-5250MHZ est uniquement pour un usage

intérieur afin de réduire les risques d'interférence nuisible aux systèmes mobiles par satellite co-

canal;

(ii)the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with

the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate;

(ii) le gain d'antenne maximal autorisé pour les dispositifs fonctionnant dans la bande 5725-5825

MHz doivent respecter le pire limites spécifiées pour le point-à-point et l'exploitation non point à

point, le cas échéant;

(iii)

User should also be advised that hight-power radars are allocated as primary users(i.e. priority

users) of the bands 5250-5350 MHz and that these radars could cause interference and/or to LE-

LAN device;

(iii) L'utilisateur doit également être informé que les radars hight-puissance sont désignés comme

utilisateurs principaux (à savoir les utilisateurs prioritaires) des bandes 5250-5350 MHz et que ces

radars pourraient cause des interférences et / ou à l'appareil LE-LAN;

RSS-102 Statement

This equipment complies with Industry Canada radiation exposure limits set forth for an

uncontrolled environment.

Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites établies

pour un environnement non contrôlé.

Specific Absorption Rate (SAR) Certification Information

Your wireless mobile device is a radio transmitter and receiver. It is designed and manufactured

not to exceed the exposure limits for Radio Frequency (RF) energy set by the Federal

Communications Commission (FCC) of the U. S. Government.

Thes

e FCC RF exposure limits are derived from the recommendations of two expert

organizations: The National Council on Radiation Protection and Measurement (NCRP) and the

Institute of Electrical and Electronics Engineers (IEEE). In both cases, the recommendations were

developed by scientific and engineering experts drawn from industry, government, and academia

after extensive reviews of the scientific literature related to the biological effects of RF energy.

The RF exposure limit set by the FCC for wireless mobile devices employs a unit of measurement

known as the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of

RF energy by the human body expressed in units of watts per kilogram (W/kg). The FCC requires

wireless devices to comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg).

The FCC SAR

limit incorporates a substantial margin of safety to give additional protection to the

public and to account for any variations in measurements.

SAR tests are conduc

ted using standard operating positions accepted by the FCC with the mobile

device transmitting at its highest certified power level in all tested frequency bands. Although the

SAR is determined at the highest certified power level, the actual SAR level of the mobile device

while operating can be well below the maximum reported value. This is because the mobile device

is designed to operate at multiple power levels so as to use only the power requi

red to reach the

network. In general, the closer you are to a wireless base station antenna, the lower the power

output of the mobile device.