Owner manual

KIT CONTENTS:
1 x LED 180 light
1 x Clear lter (tted to light)
1 x Mounting bracket
3 x M10 x 35mm stainless steel bolts
2 x M10 small stainless steel washers
1 x M10 large stainless steel washers
1 x 2 pin Deutsch waterproof connector
1 x User instructions
INSTALLATION GUIDE:
TOOLS REQUIRED:
• 17mm socket on ratchet
• Torque wrench
GENERAL CARE AND SAFETY TIPS:
To wash your lights, use plenty of warm soapy water and a soft cloth only (this prevents the surface from marking). If cleaning
the INSIDE face of your lter, use copious amounts of water and a soft cloth.
CAUTION:
Never use any solvent based cleaners or industrial detergents when cleaning your lights.
Image 1 Image 2 Image 3
MOUNTING:
LED 180 can be mounted in three different positions (two cross-bolt holes and a reversible mount; see picture)
Before tting the mount, insert the mounting bolt then select the most suitable position for your application.
LIGHTFORCE LED180
LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [e-mail]
Australia: Tel: [phone] | Fax: [phone] • Int’l: Tel: [phone] | Fax: [phone]
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © June 2014 • Data and specications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modication, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specication.
INSTRUCTION DATA
PRODUCT: LED180
VER: 1.1
DATE: JUNE 2014