User guide

IMPORTANT: DO NOT CUT ANY PART OF THE INTERNAL BALLAST OR BULB CABLES
1. DO NOT leave light connected to a power source when not in use.
2. DO NOT place light face down on ANY surface. If the light is switched on the intense heat generated
may ignite the surface and cause a melt-down of the lamp body.
3. Ensure all electrical connectors are secure - loose connections will generate excessive heat, damage
wiring and cause electrical failure.
4. The outer lens should be washed clean with copious amounts of water and a clean sponge. Wiping
it with a dry rag will scratch the lens, especially if the surface is dusty. NEVER clean the light with
 cleaninguidorsolvent.
5.DONOTattempttocleantheinsideofthelightortouchtheinsidelensandreector.
6. FOCUSING MECHANISM: The patented focus mechanism allows precise adjustment of the beam to
 variousconcentrationpatternsasdesired.SimplyrotatethereectorandselectthedesiredSPOT.
7.Ensureduringusereectorsurfaceisnotwoundtoofarforwardpasttheglobeholderormeltingof
the housing can occur and will not be covered under warranty.
8. DO NOT disassemble the light due to high internal voltage!
9. LIGHTFORCE AUSTRALIA PTY LTD shall not be liable for damage, malfunction, failure resulting from
 accident,misapplication,misuse,unauthorisedrepair,neglect,modication,unauthorisedornon-
standard replacement parts, accessories, globes, batteries or voltage or the operation of the
 productbeyonditstechnicalandenvironmentalspecications.Thepurchaseracknowledgesthat
local laws may prohibit the use of some of the product on motor vehicles travelling on public roads
and agrees that it is their responsibility to ascertain the effect of local laws.
SPECIFICATIONS:
Weight:
EF170HID - 820 grams*
EF24HID - 1130 grams*
*weight without cable
Operating Voltage at Ballast:
For 12 volt operation 9-16VDC, Nominal 12.8 volts DC
For 24 volt operation 21-29VDC, Nominal 25.6 volts DC
Power Consumption = @ 12 volts 4 amps
Recommended Operating Temperature (ambient)
-40°C > +40°C Maximum (-40°F > +104°F Maximum)
Replacement Bulb - GL24 50W 4200°K
Enforcer HID Instruction Sheet
LIGHTFORCEAUSTRALIAPTYLTD•28OrsmondStreet,HindmarshSA5007Australia•www.lightforce.com|email:[e-mail]
Australia:Tel:0884400888|Fax:0883460504•Int’l:Tel:+61884400888|Fax:+61883460504
AlllogosandimagesaresubjecttorelevanttrademarkandcopyrightprotectionLIGHTFORCEPtyLtd|©Jan2012•Dataandspecicationscontainedmaybesubjecttochangewithoutnotice.
LIGHTFORCEAustraliaPtyLtdshallnotbeliablefordamage,malfunction,failureresultingfromaccident,misuse,misapplication,unauthorisedrepair,neglect,modication,unauthorisedornonstandardreplacementparts,
accessories,bulbs,batteriesorvoltageoroperationoftheproductbeyonditstechnicalandorenvironmentalspecication.
INSTRUCTION DATA
PRODUCT: ENFORCER HID
VER: 1.0
DATE: MAY 2014