User Guide
INSTALLATION INSTRUCTIONS
IMPORTANT: Turn o power before installing or removing connector. Product to be used in accordance with local and national codes.
1.
2.
4.
5.
Strip wires 3/4” (19.1mm).
Align any frayed strands or conductors.
3. Pre-twisting unnecessary. Place stripped wires together
with ends of insulation even.
Twist screw lock rmly until hand-tight. Do not over
torque.
Wipe sealant in and around conductors and connector
opening while tightening.
Lightkiwi.com Copyright © 2017 Lightkiwi LLC, All Rights Reserved
Contact Customer Service at cs@lightkiwi.com
Landscape Lighting
Screw Lock Waterproof Wire Connector
for Low Voltage Landscape Lighting
B3578
Easy to install and suitable to use in a wide variety of
direct burial and wet location electrical connections.
Pre-lled with special insulation sealing grease for
waterproof, moisture-proof, and anti-corrosion.
Max. Voltage: 1000V
Wire Range: Min #26/Max #12
Max Temp Rating: 105 Degree C (221 Degree F)
Silicone Sealant: -45 Degree F to 400 Degree F
LIST OF WIRE COMBINATIONS
HOW TO READ WIRE COMBINATIONS
This example can be used to use one of the following combinations
one (1) 14 AWG wire with one (1) 18 AWG wire
one (1) 14 AWG wire with two (2) 18 AWG wires
one (1) 14 AWG wire with three (3) 18 AWG wires
one (1) 14 AWG wire with one (1) 20 AWG wire
one (1) 14 AWG wire with two (2) 20 AWG wires
A.
B.
C.
D.
E.
Example: 1 #14 w/ 1, 2, or 3 #18 or #20
Red Text = Number of Wires
Blue Text = Wire Size (AWG)
2 #12 2 #14 w/ 1 #16 1 #14 w/ 3 #18
1 #14 w/ 4 #20 3 #16 2 #16 w/ 2 #18
1 #16 w/ 4 #18 1 #16 w/ 5 #20 2 #16 w/ 4 #22
5 #18 6 #20 8 #20, #24, or #26
Other Combinations: Unstripped wires should have a total cross-sectional area of 16 mm2 or less.