Instruction Manual

Classified
page
11/17/2022 3
Calculite LED Gen 3 Cylinder with Remote Driver
IS-C4/C6
www.ledalite.com
Fig. D
BUSHING
RETAINING CLIP
STEM
SWIVEL BALL
HALF BALL MP
Step 2
Preparation: Install 5 wires through Stem with Swivel Ball
installed. Insert Stem through Half Ball Mounting Plate. Insert
Bushing into Retaining Clip. Slide Retaining Clip onto Half Ball
Mounting Plate, threading wires through Bushing (Fig. D).
Install Round Crossbar Plate to J-Box using 2 Mounting Screws
(not provided) (Fig. E).
MOUNTING
SCREWS
Fig. E
ROUND
CROSSBAR PLATE
Instructions for Stem Kit (CASKXX) Continued
Step 3
Wire In – Canopy: Wire to supply leads. Wire neutral supply lead
to white wire, hot supply lead to black wire, and bare copper
and/or green wire must be connected to supply ground. Use wire
nuts supplied. For 0-10V dimming, or digital dimming: wire
purple & gray leads to appropriate control wires. Place electrical
connections in J-Box.
Step 4
Install Canopy: Take assembly from Step 2 and insert the
Half
Ball Mounting Plate through the Round Crossbar Plate at an
angle. Push the remaining side up and slide into place. Use
Locking Screw to secure in place (Fig. F).
Slide Canopy Cover over the stem from the bottom up to the
ceiling until secure (Fig. G).
Fig. F
Fig. G