Instruction Manual

Classified
page
11/17/2022 5
IS-C4/C6
www.ledalite.com
Calculite LED Gen 3 Cylinder with Remote Driver
Instructions for Surface Mount C4S & C6S Series
(Remote Driver and SNS441IA Sensor Version)
Step 1
Cut sealing aperture diameter 4” then refer to UniFrame frame in
kit installation instruction sheet IS-4_N. Plenum depth for
installation must be 19” for Remote Driver Version and 22” for
Sensor Version.
Step 2
Using plate fixture(Figure A), feed driver from light engine through
the aperture hole in the ceiling. (Image is illustrative, driver can
change between models).
Note: Frame must be fixed to ceiling before installing driver.
Fig. A
Step 3
Snap driver into the j-box door (Figure A). Repeat
with remote box and snap into remote plate fixture
for alignment (Fig B). (Image is illustrative, driver
can change between models).
Step 4
After installing remote box into plate, prepare box
easy connectors for luminaire wire connection.
Instructions for Surface Mount C4S & C6S Series
(Remote Driver and SNS441IA Sensor Version)
Continued
JUNCTION BOX
REMOTE BOX
SURFACE PLATE
MOUNTING
SCREWS
Fig. A
Fig. B