Manual

PAR
4
INSTRUCTION MANUAL Page 3 of 4
MULTIPLE LENS PAR FIXTURE Version 20100224
LENS REMOVAL
1. Place the fixture on a horizontal surface with the
lens down.
2. Turn the lens rotation ring until the metal release
tab is 90
º away from the gel retaining clip on the
housing.
3. Hold one hand under the lens and press the metal
release tab to release it. Allow the lens to carefully
drop out of the fixture.
LENS INSTALLATION
1. Place the fixture on a horizontal surface.
2. Turn the lens rotation ring until the metal release
tab is 90
º away from the gel retaining clip on the
housing.
3. Slide the one edge of the lens edge under the fixed
tabs on the lens rotation ring.
4. Press the other edge of the lens down until it is
captured by the metal release tab of the rotation
ring.
OPERATION
CAUTION - HOT SURFACES
Do not touch any part if the fixture
during operation. It can operate at
temperatures which can cause severe
burns.
Do not operate the lamp unless the lamp holder is
installed in the fixture!
The lens and gel holder must be installed when the
fixture is operating.
Do not project the beam onto nearby flammable
surfaces. The minimum distance is 5 meters.
The lens may be rotated to adjust beam alignment.
This is done by rotating the lens rotation ring located
near the front of the fixture.
Once correctly installed, the fixture may be operated
by applying power via a dimmer or other compatible
power.
Switching the lamp on and off at short intervals will
reduce the life of both the lamp and the fixture.
MAINTENANCE
CAUTION RISK OF ELECTRIC SHOCK
Disconnect the fixture from power
before handling.
CAUTION - HOT SURFACES
Allow the fixture to cool off before
handling.
To ensure the reliability of the fixture it should be kept
clean. The lens and reflector should be regularly
cleaned to maintain an optimum light output.
Do not use any organic solvent, e.g. alcohol, to clean
the housing. Do NOT use glass cleaner or any type of
solvent on the reflector. When cleaning the reflector
use a damp, clean, soft, lint-free cotton cloth with a
mild, soapy water solution and gently wipe the
reflector, and then remove any soapy water residue
with a clean, soft, lint-free cotton cloth.
Do not use rough surface materials to wipe the
reflector. Cleaning frequency depends on the
environment in which the fixture operates. Moisture,
smoke or particularly dirty surroundings can cause
greater accumulation of dirt on the unit’s optics. It is
recommended that the lens be cleaned at least once
every 20 days. Clean the reflector at least once every
30 / 60 days.
TECHNICAL SPECIFICATIONS
Power Supply: 120 VAC, 60 Hz
Power Consumption: 800 Watts MAX
Dimensions: 255mm D x 280mm W x 290mm H
Weight: 4 kg
Lamp: OSRAM GLA/575 or GLE/750 (G9.5 Base)
Maximum Ambient Temperature: 45° C
Maximum Housing Temperature: 160° C