TL - 4008 MEMORY CONTROL CONSOLE OWNERS MANUAL VERSION 1.4 02/17/2005 www.lightronics.com Lightronics Inc.
Page 2 of 6 TL - 4008 MEMORY CONTROL CONSOLE Revision 1.
Page 3 of 6 TL - 4008 MEMORY CONTROL CONSOLE Revision 1.4 OWNERS MANUAL 02/17/2005 RECORD GRAND MASTER BLACK OUT X FADERS Y MODE SELECT Y FADERS CROSS FADERS MOMENTARY (BUMP) BUTTONS INITIAL SETUP CHASE SELECTORS CHASE RATE CHASE RESET (Resets chases to the factory programmed defaults): Remove power from the unit. Hold down the CHASE 1 and CHASE 2 buttons. Apply power to the unit while holding these buttons down. Continue to hold down the buttons for approximately 5 seconds then release.
Page 4 of 6 TL - 4008 MEMORY CONTROL CONSOLE Revision 1.4 OWNERS MANUAL 02/17/2005 GENERAL OPERATION OF CONTROLS CROSS FADERS: The cross faders provide the ability to fade between the upper (X) faders and lower (Y) faders. The cross fade function split into two parts giving you the ability to control the level of the upper and lower groups of faders individually. In all modes, the X cross fader must be UP to activate the upper faders and the Y cross fader must be DOWN to activate the lower faders.
Page 5 of 6 TL - 4008 MEMORY CONTROL CONSOLE Revision 1.4 OWNERS MANUAL 02/17/2005 DMX OPERATION If the DMX option is installed in the TL-4008 then it will transmit both DMX and LMX signals simultaneously. The DMX-512 connection does NOT provide console power therefore an external power supply (provided with units having DMX option) must be used. QUICK START INSTRUCTIONS The bottom cover of the TL-4008 contains brief instructions for using scenes and chases.
WARRANTY All Lightronics products are warranted for a period of TWO/FIVE YEARS from the date of purchase against defects in materials and workmanship. This warranty is subject to the following restrictions and conditions: A) If service is required, you may be asked to provide proof of purchase from an authorized Lightronics dealer.