Instruction Manual

Page 3 of 12
XC-62 COMPACT DMX DIMMER
Version 0.2 OWNERS MANUAL 03/08/2011
www.lightronics.com 20070913 drp
Lightronics Inc. 509 Central Drive Virginia Beach, VA 234354 757 486 3588
XC-62 UNIT DESCRIPTION
The XC-62 is a six circuit compact dimmer with a
load capacity of 1200 Watts per circuit. Each circuit
is protected by a 10 Amp fuse. It can be controlled in
several ways - the most common being DMX-512.
Other control modes are also provided for stand alone
operations. These include individual channel control
and chaser functions. Individual circuits may be
operated as non-dim (relay) circuits. Individual
circuits may be set for one of several response curves
and may be limited to less than full intensity. In
addition to full soft patch capability there is a quick
pack address function which enables rapid setup.
The XC-62 can optionally be provided with a wireless
DMX receiver.
INSTALLATION
POWER REQUIREMENTS
The XC-62 operates from two separate 120VAC, 20
Amp service feeds. Each feed must include a
NEUTRAL and a safety GROUND. The unit is
provided with power cord stubs containing Edison
plugs for this purpose.
One power cord supplies the power for channels "A",
"C", and "E". The other one supplies channels "B",
"D", and "F".
The combination of the lighting loads on EACH of
these power feeds can not exceed 2400 Watts (20
Amps).
LOCATION AND MOUNTING
Locate the unit in a well ventilated area away from
moisture and heat. The unit should be operated in free
air to ensure good air flow around all sides. Do not
block any of the vent holes.
THE XC-62 COMPACT DIMMER PACK IS
INTENDED FOR INDOOR USE ONLY.
Two 1/2" diam. holes are provided at the top of the
unit for a lighting bar pipe clamp and a safety cable.
LOADS AND LOAD CONNECTIONS
Lighting fixtures connect to the 6 duplex outlets on
one side of the unit. They are designated as "A"
through "F". There are two load connections per
circuit. Each circuits is referred to as a "channel". A
diagram is provided on the unit which identifies each
channel.
Each XC-62 channel has a 1200 Watt MAXIMUM
rating and is protected by a 10 Amp fuse. 10 Amps
equates to 1200 Watts at 120VAC. If you operate a
channel at 1200 watts then you are very close to
blowing its fuse. This will occur if AC line voltages
are high or you have power surges. Other conditions
which may cause the fuse to blow include turning a
cold lamp quickly on to full intensity.
A practical working load is 1000 Watts per channel.
DMX CONTROL SIGNAL CONNECTIONS
DMX control is connected via the male 5 pin XLR
connector located in the end of the dimmer. A female
5 pin XLR is also provided so you can chain the
connection to other dimmers or other DMX devices.
Wiring information for the XLR connectors is shown
below.
DMX OUT
DMX IN
MALE
FEMALE
A
B
C
D
E
F
A
B
C
D
E
F