Instructions / Assembly

Notch

Nib

DIRECTION FOR INSTALLATION

1. Be careful when taking out the product:

2. Adjusting the trunk to fit the nuts on the base and fix it with screws（9PCS） by wrench included.

4. Find the wire joints inside the upper & bottom trunks. Connecting the joints, insert the upper trunk

into the bottom one and fix the trunk with the screw preinstalled by Allen wrench.

INSTRUCTION

Small Tree

Middle Tree

Tree Top

Wrench

Pedestal

spare part

4 Stakes

Outdoor Adaptor

- Power supply: 3.5V adaptor, IP44 rainproof

- Input: 120V AC 50/60Hz

- Output: 3.5V DC 3.5W

5. Wrapping the light string around the tree trunk from the tree top to the bottom. Spreading the

leaves to make it looks full at your own choice.

Important Notes:

This product is not designed to withstand strong winds, please keep the product sheltered on





Tree Trunk Part 1

Tree Trunk Part 2

3. Connect Big Tree with Middle Tree, then connect Middle Tree with Small Tree.

Notch

Nib

Notch

Nib

Middle Tree

Big Tree

Small Tree

Big Tree

PAGE 1
3. Connect Big Tree with Middle Tree, then connect Middle Tree with Small Tree. DIRECTION FOR INSTALLATION 1. Be careful when taking out the product: Tree Top Small Tree Nib Notch Small Tree Middle Tree Tree Trunk Part 1 Big Tree Middle Tree INSTRUCTION Nib Notch Tree Trunk Part 2 4. Find the wire joints inside the upper & bottom trunks. Connecting the joints, insert the upper trunk into the bottom one and fix the trunk with the screw preinstalled by Allen wrench.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS When using outdoors, please install to a covered weather proof GFCI electrical outlet. Make sure the adapter and cord are assembled correctly and secured tightly to prevent from water. 1. Please read and follow all instructions and warnings on the instructions and product carefully before using. 2. Retain the instruction for future reference. 3. This product should be used only as intended. 4. For indoor/outdoor use. 5.
PAGE 3
Replace the ba�ery of the remote control. On Back Battery Included PR ESS IR RECEIVER 1. Control Bu�on: Press bu�on to change between 8 diﬀerent modes; 2. To set and reset �mer press bu�on for 3 seconds, Green light ON means �mer is ON(6H ON/18H OFF). REMOTE CONTROL ON TIMER OFF 1 2 3 4 5 6 7 8 DIM+ DIM- Press this bu�on to turn on/oﬀ the light Press this bu�on to ac�vate the �mer (6hrs on and 18hrs oﬀ) 1. Combina�on 2. In waves 3. Sequen�al 4. Slo-glo 5. Chasing/ﬂash 6. Slow fade 7.