User's Manual

1. Overview 2. Initial Set-up 3. DaiIy Operation

4. Additional

Information

5. Maintenance &

Troubleshooting

6. Safety &

Speciﬁcations

1. Insert all four pods into the charging cradle. Each pod’s charging light will

turn red to indicate normal charging. When fully charged, they will turn

green. For systems with 5-6 pods, use the charging cables to connect pods

#5-6 into the charging jacks on the side of the charging station.

2. Insert the Flexmike(s)* into the appropriate smaller center slot. The blue

microphone 1 or 2 light will blink for several seconds as it establishes a link,

then turn solid. The charging light will turn red to indicate normal charging.

When fully charged, it will turn green.

3. Insert the teacher remote(s)** into the appropriate charging slot. The

charging light will turn red to indicate normal charging. When fully charged,

it will turn green.

FOR SYSTEMS WITH 2 MICROPHONES AND REMOTES:

*If you have two Flexmikes, you will want to power them on to determine

whether it is Microphone #1 or #2 (indicated by blue light), then place it in

the appropriate charging slot.

**Check the serial number label on the back of the remote to determine

whether a remote is set to Microphone #1 or #2, then place it in the

appropriate charging slot.

3. CHARGE THE FLEXCAT COMPONENTS

Prior to full operation, all system components should be fully charged (at least 8

hours) to ensure optimum performance.