User's Manual

30
1. Overview 2. Initial Set-up 3. DaiIy Operation
4. Additional
Information
5. Maintenance &
Troubleshooting
6. Safety &
Specifications
Ensure teacher remote is working properly.
- Press the center “Whole Class” button. It should be lighted green.
- If it doesn’t light, make sure the Redcat Access is plugged into power and
the blue power light is on.
- Ensure there is a corresponding green 1 or 2 ready light on the Redcat
Access.
- Ensure the batteries are fully charged. If the red battery low light is on, it
can experience intermittent operation.
PROBLEM: Remote does not light or activate a speaker pod(s).
SOLUTION:
Ensure the batteries have a charge. They should be charged nightly.
- If the red low battery light is on, it can experience intermittent operation.
Try pressing the center “Whole Class” button. It should be lighted green.
- If this button lights, the remote has a battery charge and is properly linked
up. The problem is likely with the pod or pods that do not activate, refer to
the “No audio from speaker pod” troubleshooting section.
- If this button doesn’t light, make sure the Redcat Access is plugged into
power.
- Check to see that there is a corresponding green 1 or 2 ready light on the
Redcat Access.
- Check to see that the Flexmike is powered on and linked, as indicated
by a solid blue light. If that light does not go solid blue, try powering the
Flexmike and Redcat Access off, then on again.
- If the microphone still does not link up (turn solid blue), it may need to be
re-registered to the Redcat Access. Please refer to the Flexcat registration
guide on the Lightspeed website.
- If there is a second remote, check to see if that operates correctly.
PROBLEM: Feedback or squealing from pod speaker
SOLUTION:
Make sure the teacher’s Flexmike is 2 feet or more away from the pod.
Operation at very close distance can cause feedback.
Try turning the volume down on the bottom of the pod. Typical volume levels
should be around the mid-point (12:00 on the dial).
Make sure the teacher’s Flexmike is 2 feet or more away from the pod.
Operation at very close distance can cause feedback.
Turn the volume on the Flexmike down 1-2 clicks.
TROUBLESHOOTING CONT’D