User's Manual

12
1. Overview 2. Setup & Use
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
2A. SETTING UP ONE DELTA PA RECEIVER
1. Turn the Delta PA ON by rotating
the RCVR 1 knob clockwise. The
GREEN LED will light.
Channel Selection: Receiver
Each Receiver has 16 user-selectable
channels to choose from. You can
either select a channel manually or by
pressing the SCAN button, which will
automatically select a clear channel.
2. Clear Channel SCAN
(recommended):
A) Make sure the transmitter(s) is
OFF before pressing this button.
When this button is pressed, the
receiver will cycle through all
16 channels and select a clear
frequency. (This process takes
about 20 seconds.)
B) Once the receiver selects the
clear channel, you will need to
select the same channel on the
corresponding transmitter
(handheld or belt-pack). See pages
11 and 16 for instructions.
NOTE There are 3 different groupings
of 16 channels available (620, 645,
670 MHz). Make sure the receiver
module frequency group is the same
frequency group as the transmitter.
ON
Channel 2
POWER
CHARGE
RED: LOW BATT
GREEN: ON
RED: CHARGING
GREEN: FULL
RECVR 1
RECVR 2
RECVR 2
O/I
POWER/
RECVR 1
POWER
CHARGE
RED: LOW BATT
GREEN: ON
RED: CHARGING
GREEN: FULL
RECVR 1
RECVR 2
RECVR 2
O/I
POWER/
RECVR 1