User Manual

SEC
TION 5:
MAINTENANCE &
TROUBLESHOOTING
REGISTRATION OF REPLACEMENT OR
ADDITIONAL EQUIPMENT
In order for all system components to operate and communicate with one
another, they must be registered to the Access classroom audio system. When
purchased as a complete system, major components (Access audio system,
Flexmikes, remotes, and pods) will be pre-registered and ready for use, so there
is no need to manually register anything.
In the event a component needs to be replaced or an additional component
is added down the road, it will need to be registered. Please refer to the
Registration Guide provided with the new components or on the Lightspeed
website.
BATTERY REPLACEMENT
Overview of batteries
The pods and Flexmike contain rechargeable battery packs that require daily
charging. The battery packs are covered under warranty for 1-year but have a
useful life of about 2+ years before they should be replaced. The battery packs
must be purchased directly from Lightspeed, and can easily be installed by the
user.
Replacement of battery pack in pod
1. Slide the battery door open.
2. Pull the battery pack out and disconnect
the cable.
3. Take the new battery pack, connect the
cable and insert the battery pack into the
compartment.
4. Slide the cover back on.
5. Place the pod in the Activate station to
fully c
harge the new battery pack.
6. The charging light will turn red. It will
turn green when fully charged (up to 10
hours).
WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. When
transporting any battery outside of a product, keep battery enclosed in plastic
so as to prevent a short circuit and unintentional activiation.
6.
Safety
&
Specifications
4.
Additional
Information
3.
DaiIy
Operation
2.
Initial
Set-up
1.
Overview
5.
Maintenance
&
T
r
oubleshooting