User Manual
Table Of Contents
- U s e r M a n u a l
- SYSTEM COMPONENTS AND UNPACKING
- OPTIONAL COMPONENTS
- POD CONTROLS AND CONNECTIONS
- ACTIVATE STATION: CONTROLS, CONNECTIONS AND INDICATORS
- ACTIVATE STATION: CONTROLS, CONNECTIONS AND INDICATORS
- 2. PLUG IN THE ACTIVATE STATION
- 3. PLACE THE COMPONENTS IN THE ACTIVATE STATION
- 5. REGISTER ANY NEW ACTIVATE SYSTEM COMPONENTS
- 6. DOWNLOAD THE MOBILE APP
- 7. PAIR YOUR MOBILE DEVICE TO ACTIVATE STATION
- 8. SET UP THE FLEXMIKE + EARBUD
- 9. SET THE PODS OUT IN THE CLASSROOM
- 10. TEST GENERAL SYSTEM OPERATION
- 9. SETTING SYSTEM VOLUME LEVELS
- DAILY OPERATION INSTRUCTIONS
- ADDITIONAL OPERATION INFORMATION
- MAINTENANCE & TROUBLESHOOTING
- WARRANTY, SAFETY & SPECIFICATIONS
TROUBLESHOOTING
CONT’D
PROBLEM: LS Remote app shows message “Attempting to Connect” or “Paired
remote is out of range or has no power.”
SOLUTION:
•
This indicates the Bluetooth signal between your device and the Flexcat
remote are hav
ing trouble communicating, usually due to range between the
iOS device and the remote or a dead battery in the remote.
•
Make sure your device is within 50-100 feet of the remote. Walk up to the
remote and wait several seconds for the app to reconnect.
•
If it does not automatically reconnect, try force quitting the app: double tap
the Home button on y
our iOS device, then swipe up the LS Remote app to
close it. Re-open
the app and it should connect automatically.
•
Make sure your remote is active with a charged battery. Place it on the charger
and make sure the Red (or green) charging light is on.
PROBLEM: LS Remote app shows “No Response from the Flexcat System”
SOLUTION:
•
This indicates the Flexcat remote is not communicating with the Access
amplifier, us
ually due to range between the remote and the amplifier.
•
Make sure the remote is within 100 feet of the Access amplifier. Walk up within
range of the Access amplifier and attempt to select a pod using the remote. If
that works, your app will begin working as well.
•
If it does not automatically reconnect, try force quitting the app: double tap
the Home button on y
our iOS device, then swipe the LS Remote app up to
close it. Re-open
the app and it should connect automatically.
•
Keep the remote within range of the Access amplifier for continuous
operation.
•
If the handheld remote does not operate, make sure the remote is paired
to the Access a
mplifier. If this remote has not been used before, it must be
paired t
o the Access amplifier.
- Using a paperclip, press the Registration button on the Access amplifier,
the #1 and #2 lights on the amplifier will begin blinking.
- Now use the paperclip to press the registration button on the back of the
remote.
- The #2 light on the Access amplifier will turn off to indicate the remote is
now pai
red.
- Within a few seconds, the LS Remote app should detect the Flexcat
system.
5.
Maintenance
&
T
r
oubleshooting
4.
Additional
Information
3.
DaiIy
Operation
2.
Initial
Set-up
1.
Overview
6.
Safety
&
Specifications