User's Manual

12
1. Overview 2. Installation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
3. SECURING THE TOPCAT
To comply with Building Codes, the TOPCAT MUST be fastened to the ceiling
grid and secured with a safety wire.
1. Locate the four (4) self-drilling sheet metal screws.
2. Utilizing existing center holes on the vertical section of the ceiling grid, drill
one screw per side on opposite sides of the TOPCAT (see figure 4).
3. Locate the 15ft length of safety wire and the eye screw. The safety wire needs
to be permanently attached to the solid structural ceiling above.
4. Install the eye screw (or concrete anchors if necessary) into the structural
ceiling.
5. Loop one end of the safety wire through the eye screw (or anchor), then twist it
around itself at least five times.
6. Pull one of the tabs up on the TOPCAT rear panel (located in opposite corners)
and loop the other end of the safety wire through the tab. Pull the wire
through until it is taught and twist it around itself at least five times to secure
the speaker. Cut off any excess wire if needed. (see figure 5)
Figure 4: Secure with Self-Drill Screws into the TOPCAT
Figure 5: Looping the Safety Wire Through the Tab