User's Manual

19
1. Overview 2. Installation
3. Optional
Accessories
4. Troubleshooting
5. Warranty, Safety
& Specifications
The TOPCAT and Media Connector must be registered or synchronized with
each other before they will operated together. (These modules come pre-
registered from the factory.) On occasion, one of these modules may be
replaced so the registration process will be needed.
Use the following table to determine if your TOPCAT and Media Connector are
registered.
NOTE: If the link LED on the MC module is continuous green, the following
procedure does not need to be done.
To register TOPCAT with its Media Connector Module:
1. Locate the registration button on the side of the TOPCAT module.
2. Start the procedure by pushing the
registration button. You will have 20
seconds to push the corresponding
registration button on the Media
Connector.
3. Push the registration button on
the Media Connector Module. The
amber LED will begin to blink. When
registration process is complete, the
LINK LED will glow green and the
amber LED will go off.
9. TOPCAT AND MEDIA CONNECTOR
REGISTRATION
Paging
Input
Microphone
Volume
Registration
AB
Aux Power IN
DC: 24V/2.5A
Adj.
TOPCAT
Registration Buttons
NOTE: If after pushing the
Registration button on TOPCAT the
corresponding button on the Media
Connector is not pushed within 20
sec., the amber LED will go from
a slow blinking to a fast blinking.
This means the registration process
has timed out. Wait until the amber
LED stops blinking to start the
registration again.
Media Connector
MC Power MC LINK LED Status
OFF All LEDs Off Turn MC Power ON Blue
LED is LIT
ON Blinking Green Not Linked - Needs to be
registered
ON Continuous Green Linked to TOPCAT