User's Manual

User’sGuide 
deliberant Page10
ConfigurationGuide
This document contain product‘s powerful web management interface configuration description
allowing setups ranging from very simple to very complex.
ApplingandSavingConfigurationChanges
There are three general buttons located on the right top corner of the WEB GUI allowing managing
device configuration:
Save changes – if pressed new configuration settings are applied instantly and written to the
permanent device memory.
Test changes – if pressed the device will start operating with newly set configuration settings for
3 minutes. During this test time the administrator is able to gauge if device is working properly,
and then Save changes. In case wrong settings were chosen (or even after faulty settings
administrator have lost connection with the device), the device automatically reverts back
configuration to an old one.
Discard changes – if pressed parameter changes are discarded. It should be noted that if Save
changes is pressed it is not possible to discard changes.
Status
After login, the main Web management page displays Status Information page. The header of Web
management page displays main information about device: Firmware version, Product name, Uptime,
CPU load, Ethernet port(s) status, Connected client count.
Information
The Information page displays a summary of status information of your device. It shows important
information for the APC operating mode, radio and network settings.
If APC device is dual-band, then Information page will be divided into two tabs (for 2.4GHz and 5Ghz
radio), each containing appropriate information.
Radio – displays summary of the radio interface configuration.
Wireless – displays general information about the wireless connection. The wireless information will
differ on Access Point, Station, iPoll wireless modes:
 Access point (autoWDS) and (Access Point (iPoll 2) – displays access point operating
information: SSID, Security type, SSID Broadcast status, VLAN and number of connected clients.
 Station (WDS/iPoll) and Station (ARPNAT) – displays settings at which the station is
connected to the access point: SSID, Security type, Peer’s MAC address, Tx/Rx rate, Protocol.
Network mode – displays short summary about current network configuration (bridge or router).