User's Manual
User’sGuide
deliberant Page12
Subnet mask – specify a subnet mask for device.
Default gateway – specify a gateway IP address for device.
DNS server – specify the Domain Naming Server.
Secondary IP – specify the alternative IP address and the netmask for APC unit management.
IPv6Configuration
Click the IPv6 slide to enable IPv6 configuration:
IPv6 method – specify IPv6 reception method: IPv6 addresses can either be retrieved from a
DHCPv6 server or configured manually:
Static – the IPv6 address must be specified manually.
Dynamic stateless IP – the DHCPv6 client only obtains network parameters other than
IPv6 address
Dynamic stateful IP – the DHCPv6 clients require IPv6 address together with other
network parameters (e.g. DNS Server, Domain Name, etc.).
IPv6 address – specify the IPv6 Address for the interface.
IPv6 prefix length– enter the Prefix Length for the address.
IPv6 default gateway – specify IPv6 address for default gateway.
IPv6 DNS server – specify the Domain Naming Server IPv6 addresses.
RouterIPv4Mode
This section allows customizing parameters of the Router to suit the needs of network, including
ability to use the built-in DHCP server. When device is configured to operate as Router, the following
sections should be specified: WAN network settings, LAN network settings and LAN DHCP settings.
Enable NAT – select to enable NAT (Network Address Translation), that functions by transforming the
private IP address of packets originating from hosts on your network so that they appear to be coming
from a single public IP address and by restoring the destination public IP address to the appropriate
private IP address for packets entering the private network, the multiple PCs on your network would
then appear as a single client to the WAN interface.
WANSettings
WAN network settings include settings related to the WAN interface. The access type of the WAN
interface can be configured as: Static IP, Dynamic IP, PPPoE client.
IP method – choose Static to specify IP settings for device WAN interface:
IP address – specify static IP address.
Subnet mask – specify a subnet mask.
Default gateway – specify a gateway.
DNS server – specify primary and/or secondary DNS server
Secondary IP – enable to specify the alternative IP address and the netmask for APC unit
management.
WAN mode – choose Dynamic to enable DHCP client on the WAN side. This option does not need
any parameters:
DHCP fallback setting – specify IP address, Subnet mask, Default gateway and optionally DNS
server for DHCP fallback. In case the APC unit will not get the IP address from the DHCP, the
specified fallback IP settings will be used.
Enable secondary IP – specify the alternative IP address and the netmask for APC unit management.
DNS servers – allows selecting if automatically assigned or alternative DNS servers should be used
WAN mode – choose PPPoE to configure WAN interface to connect to an ISP via a PPPoE: