User's Manual

Technical Description & Configuration Guide Configuration and Management
LigoWave Page 14
There are four ways to adjust and read settings and operation parameters of the LigoPTP 24 FODU
equipment:
 using Web terminal connected to the 10/100Base-T management port,
 using Telnet terminal connected to the 10/100Base-T management port,
 using NMS or SNMP terminal, connected to the 10/100Base-T management port, or
 using ASCII console connected to the serial port.
Resetting the LigoPTP 24 FODU
Depending on the method used, the user may reset the whole terminal or the management controller
individually, see table below for details.
Resetting
Description
Reset action unplugging power
source.
Restarts both the multiplexer module and the
management module. Resets all management counters.
Resetting with
button in Web GUI
 System

command prompt command
system reset
Restarts CPU of the management controller. Resets all
management counters.
Resetting with command
system
reset cold
Restarts modem and CPU of the management controller.
Resets all management counters.
Web Interface
This section will describe the points necessary for working with the Web interface.
10/100Base-T Port
The 10/100Base-T management port is used to connect the LigoPTP 24 to a PC or Ethernet network
for Web, SNMP and Telnet management.
The 10/100Base-T port cable length must not exceed 100 meters.
Assembling the Ethernet Cable Connector
Be aware that length of RJ45 connectors may vary! This is the reason why weatherproof
connector enclosure has room for longest possible RJ45 connector.
This instruction will show you how to correctly assemble weathered connector and have best possible
connection of RJ45 connector with socket.
Configuration and Management