User's Manual

Technical Description & Configuration Guide Configuration and Management
LigoWave Page 31
After you have correctly entered the login and password, you are ready to work with all the available
command prompt commands.
Initial Configuration with Command Prompt
Configuration steps using command prompt are as follows:
Step 1. Check the system settings with command status
Step 2. Configuration required parameters:
 Tx power with the command radio txpower [<power dBm>];
 Tx frequency with the command radio freq [<freq KHz>];
 modem bandwidth <
among 7, 14 or 28 MHz values;
Before you set above mentioned parameters, you must know what frequency and
bandwidth you may use and at what power you may transmit.
 Modulation with the command modem modulation <QPSK|16APSK|32APSK> [wide] [ACM];
 Number of E1 channels with the command e1 set <Number of E1 channels>;
 Name of LigoPTP 24 FODU with the command system name <name>. Default name is
LigoPTP
 IP address with the command net ip addr <addr>, if it is necessary;
 IP mask with the command net ip mask <mask> , if it is necessary;
 IP default gateway with the command net ip gw <gw> , if it is necessary;
 Remote IP address with the command net ip remaddr <remaddr>, if it is necessary;
Step 3. Save settings with the command cfg write; restarting with the command system reset;
Step 4. Check the settings made, modem and radio status with the commands status, modem
status and radio status respectively.