User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 45
Pressing Execute configuration applies changes made to the corresponding section only for the local
side LigoPTP 24 FODU. If Rollback on is selected, configuration will be reverted in case of erroneous
configuration changes applied.
IP Services
FTP service – starts FTP service for file access and software update of your LigoPTP 24 FODU. By
default FTP service is not running (command line net start ftp);
TFTP service – starts TFTP service for file transfer between both LigoPTP 24 FODU link sides. By
default TFTP service is not running (command line net start tftp).
Static Route Configuration
Do not make any changes to default route; otherwise, management connection to
LigoPTP 24 will be lost.
Static routes shows the list of existing static routes, as well as allows you to choose specific route
you are willing to change or delete. By default there is one route which depends on earlier entered IP
settings (command line net route);
Network address allows specifying network address for the route changing/adding (command line
net route add|delete <dest addr> [MASK <mask>] <gateway>);
Network mask - allows specifying network mask for changing/adding the route (command line net
route add|delete <dest addr> [MASK <mask>] <gateway>);
Gateway - allows specifying gateway for the route changing/adding (command line net route
add|delete <dest addr> [MASK <mask>] <gateway>);
After entering addresses or selecting a specific route, buttons Add, Change and Delete allow you to
modify LigoPTP 24 FODU routes. If Rollback on is selected, configuration will be reverted in case of
erroneous configuration changes applied.
Write to config file writes to configuration file all the changes made on the whole page (command
line cfg write);
FODU returned - in case of error or incorrectly entered parameter value, or other problems on the
whole page
Additional network configuration commands in Telnet/serial interface:
Command
Description
Net ping <ip>
This command is for troubleshooting purposes to verify
the service channel connectivity, - it sends a special
packet to the specified address and then waits for a reply.