User's Manual

Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 46
Command
Description
Net telnet <host>
[<port>]
Opens Telnet session with the FODU, host  IP address
of the FODU management Ethernet port.
Net tftp <host> {get|put}
<source>
[<destination>]
Uploads or downloads (put/get) file (<source>) to or from
the host FODU (<host>).
Web trace {show|on|off}
Web trace allows you to see commands being executed

connection. Show – shows web trace status (on or off), on
– turns web trace on, off – turns web trace off.
Web timeout <time in
minutes>
Allows setting the time, after which the Web GUI
presumes no connectivity state. By default the value is set
to 15 minutes.
Below is the explanation of the procedure of network IP configuration in case of network IP Class area
change.
For the purpose of illustration, we use B class IP network address 10.0.10.11 for the remote side
LigoPTP 24 and 10.0.10.10 for the local side LigoPTP 24, while the IP address of our management PC
LAN adapter will is 10.0.0.1.
The steps of the configuration procedure are as follows:
Step 1. Enter the remote side (far-end) Web GUI first (in the following case it is 192.168.205.10)
and go to IP configuration. The configuration in this particular example will look in the
following way:
Rollback on should not be selected.

Step 2. Enter the local side (close-end) Web GUI and go to IP configuration. The configuration will
look in the following way:
Rollback on should not be selected.
Press Execute configuration.
Step 3.  
Chapter
Ethernet Management Connection Configuration. Configuration of LAN Ethernet port must
be as follows: