User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 48
Ethernet Configuration
LAN connection allows choosing LAN speed and duplex. You are able to choose between 10 Mbps
Half Duplex (10hdx), 10 Mbps Full Duplex (10fdx), 100 Mbps Half Duplex (100hdx), 100 Mbps Full
ethernet set lan
connection [auto|10hdx|10fdx|100hdx|100fdx]);
LAN flow control allows enabling or disabling LAN flow control (command line ethernet set lan
flowcntrl enable|disable);
Mng bandwidth allows limiting bandwidth for the Management port. Possible choices are 128 Kbps,
256 Kbps, 512 Kbps, 1 Mbps, 2 Mbps, 4 Mbps and Full (command line ethernet set mng bandwidth
[128 | 256 | 512Kbps | 1 | 2 | 4Mbps | Full]);
Pressing Execute configuration applies changes made to the corresponding section only fr the local
side LigoPTP 24 FODU. If Rollback on is selected, configuration will be reverted in case of erroneous
configuration changes applied;
Pressing Execute configuration applies changes made to the corresponding section;
Write to config file writes to configuration file all the changes made on the whole page (command
line cfg write);
FODU returned - in case of error or incorrectly entered parameter value, or other problems on the
whole page
VLAN Configuration
The VLAN configuration window provides configuration of port-based Ethernet Virtual Local Area
Networks (VLANs), allowing using up to 16 different VLAN IDs. It is possible to assign 3 different
modes to your VLANs Trunk (LAN port is interconnected with WAN port and Management port is not
accessible useful for configuring customer VLANs), Management (all ports are interconnected) and
Access (all VLAN tagged packets are being untagged at LAN egress port and tagged at LAN ingress
port).
Note, that Trunk and Access type VLANs cannot be configured together.
802.1Q VLAN enables support of 802.1Q VLAN (command line ethernet vlan [enable | disable]);
Management VLAN ID allows specifying Management VLAN ID. When already configured, shows
current Management VLAN ID (command line ethernet vlan <VLAN ID> management);