User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 49
LAN port mode specifies LAN port operation mode for user traffic VLANs with tagging/untagging
packets (Access) or passing through already tagged packets (Trunk) (command line ethernet vlan
<VLAN ID> [Trunk | Access]);
Pressing Execute configuration applies changes made to the corresponding section only for the local
side LigoPTP 24
configuration changes applied;
Trunk VLAN number allows to specify and add Trunk VLAN ID. If Rollback on is selected,
configuration will be reverted in case of erroneous configuration changes applied (command line
ethernet vlan <VLAN ID> [Trunk | Access]);
Reset VLAN resets the whole VLAN configuration (command line ethernet vlan reset);
Write to config file writes to configuration file all the changes made on the whole page (command
line cfg write);
FODU returned in case of error or incorrectly entered parameter value, or other problems on the
whole page the info
To ensure correct operation of VLANs, both individual VLAN IDs and general 802.1Q VLAN should be
enabled.
Ethernet Switch Port Status and Settings
Switch port 1 (LAN) is connected to LAN interface.
Switch port 2 (WAN) is connected to WAN interface, modem and radio part.
Switch port 3 (Mng) is connected to LAN Management CPU.