User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 56
DSCP Configuration
QoS DSCP provides mapping of different traffic DSCP classes to priority queues.
DSCP mapping allows assigning queues for different DSCP classes. You may have up to 64
different traffic DSCP classes;
Pressing Execute configuration applies changes made to the corresponding section only for the local
side LigoPTP 24 FODU. If Rollback on is selected, configuration will be reverted in case of erroneous
configuration changes applied;
Write to config file writes to configuration file all the changes made on the whole page (command
line cfg write);
FODU returned - in case of error or incorrectly entered parameter value, or other problems on the
whole page
QoS 802.1p Bandwidth Configuration
QoS 802.1p bandwidth provides configuration of bandwidth limiting on all three ports, thus allowing
you to gain best results from your LigoPTP 24 based system.