User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Detailed Configuration in Web
LigoWave Page 58
Pressing Execute configuration applies changes made to the corresponding section only for the local
side LigoPTP 24 FODU. If Rollback on is selected, configuration will be reverted in case of erroneous
configuration changes applied.
SNMP Allowed Hosts Configuration
SNMP host list shows the list of available SNMP hosts; adds or deletes the host IP address to the
LigoPTP 24 SNMP host table. If the SNMP host connected to the LigoPTP 24 is not added to the
LigoPTP 24 SNMP host table, the LigoPTP 24 will not respond to the SNMP requests from that host. If
applied. (command line snmp host {add | delete} <ipaddr>);
Write to config file writes to configuration file all the changes made on the whole page (command
line cfg write);
FODU returned - in case of error or incorrectly entered parameter value, or other problems on the
whole page