User's Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- LigoPTP 24 Full Outdoor Units
- LigoPTP 24 Feature Summary
- Radio Parameters
- Application Examples
- Technical LigoPTP 24 Specification
- Cable Requirements
- Labeling
- Resetting the LigoPTP 24 FODU
- Web Interface
- Command Prompt Interface
- Radial MSE
- LDPC
- Main Configuration
- System Configuration
- IP Configuration Window
- Ethernet Configuration
- VLAN Configuration
- QoS
- SNMP Configuration
- Alarm Management
- Performance Management
- Ethernet Statistics
- Configuration File
- License Management
- Command Line
- File System
- Security Commands
- Other Available Accessories
- List of Abbreviations
Technical Description & Configuration Guide Miscellaneous Controls in Web
LigoWave Page 75
These controls are
Configuration File
This section allows working with LigoPTP 24 configuration script.
The management module has RAM and EEPROM chips onboard. When LigoPTP 24 is booted up,
bootstrap is loaded from the EEPROM into RAM. The bootstrap contains the parameters that were
previously stored in EEPROM using write and/or cfg write commands. These parameters are stored
in EEPROM in the form of script and when booting up, the script parameters are loaded into RAM.
These parameters can be freely changed in run-time, - changing the data in RAM. If the LigoPTP 24 is
shut down without saving the current configuration (script) in EEPROM, the original configuration will
be restored from EEPROM on the next boot-up.
Example of script can be observed on the screenshot below.
The script can be edited:
string can be added by simply entering required string (see Nr. 7 on the screenshot below) or by
executing command in CLI or in the appropriate Web GUI section (the script will be supplemented
with the new string or the instant string entry will be updated);
string can be deleted by entering appropriate line number (see Nr. 2 on the screenshot below) or
cfg delete
The changes can be saved in EEPROM by pressing Cfg write button (see Nr. 3 on the screenshot
cfg write command in CLI.
The parameters that are not specified in the configuration script will have their default
values when the LigoPTP 24 is restarted.
Explanation of customization fields:
Configuration file window shows contents of configuration script. Commands contained in this
configuration script are executed at every system start-up (command line cfg show);
Delete entry # – allows deleting a specific line of configuration script. You must type the number
represented in configuration script to proceed with deleting and press Delete (command line cfg
delete <line>);
Save edited configuration file – to confirm the changes made, you must write configuration script
into EEPROM, otherwise changes will not be saved (command line cfg write);
Miscellaneous Controls in Web