Datasheet

Specifications subject to change without prior notice.

It is the responsibility of the product user to determine the suitability

of LINAK A/S products for a specific application. LINAK will at point of

delivery replace/repair defective products covered by the warranty

if promptly returned to the factory. No liability is assumed beyond

such replacement/repair.

LA12 ATEX

Facts about LA12 ATEX version.

LINAK is able to supply LA12 ATEX for dust explosive atmospheres zones 21 and 22.

There are some differences between the “standard” LA12 and the “LA12 ATEX”

SUPPLEMENTARY FOR LA12 ATEX

Installation instructions.

The actuators model LA12 shall be used in a permanantly ﬁ xed installation.

Special conditions for safe use:

The permanently attached cable shall be terminated in a non-hazardous area or inside an enclosure that is certiﬁ ed under

the type of explosion protection as described in EN 50014 clause 1.2.

The duty cycle of the actuator is limited to 6 minutes ON - 54 minutes OFF.

The actuator model LA12 is to be installed where it is protected from direct sunlight.

Standard LA12

Can be opened and

modified by subsidiaries

Housing is made of plastic

Inner tube is made of plastic

Installation dimension 245mm

LA12ATEX

Must be opened and modified by LINAK A/S only due to the fact

that our quality systems have been approved according to ATEX.

Housing is made of plastic but coated with grey painting that is

conductive. This is to prohibit static electricity.

Inner tube is made of stainless steel – the same as used on LA22.

This to prohibit static electricity.

Installation dimension 255mm due to the fact that the inner

tube is made of stainless steel.