User's Manual

Starting a massage program always turns on both motors at current intensity.
Short key press on right key turns off both massage motors no matter if it is
running in a massage program, or separately.
Keep key pressed to adjust the motor change speed up or down (left key
down, right key up.)
Store and recall massage settings.
2 massage settings can be stored.
Adjust the massage to the preferred settings. Pres the “S” key followed by
either key “1” or “2”. To recall a pervious stored setting pres key “1” or “2”.
In general
Massage will turn off automatically 10 min. after the last adjustment of the
settings.
Adjusting the bed will turn off the massage, but massage will automatically start
up again afterwards.
When turning on a single massage motor it will start up with the same intensity
as it was last time it was running as a single motor.
When turning on a massage program it will start up with the same settings
(program, motor change speed, intensity) as it was last time.
Turning on a massage function can also be done by keeping the up key pressed.
Then it will turn on, and after a short delay adjust the intensity up.
Massage functions can only be controlled by the transmitter. The receiver is a
standard hand control.
Pressing any key on the receiver will stop the massage, and adjust the bed
according to the key pressed. After releasing the key, massage will automatically
start up again.
In case of any errors: current-limitation, high temperature or short-circuit, the
massage system will stop both motors, even if only one motor is affected.
Normal operation
In normal mode to adjust the bed position, the hand control is working exactly
as a normal Handset without massage functionality, except there are only 2
memory positions instead of 3.
If there are any extra motors in the system, the keys to control these motors
will, as normal, be placed between the leg rest keys and the “reset and massage
program” keys.
11