User's Manual

• After having activated the RF handset keys; the reset key must be released.

• If no RF handset keys are activated during the matching procedure; no

changes are made in the ID memory of the TD3.

Start-up - How to install RF handset:

The TD3 can accept commands from up to 2 RF handsets.

From the factory the TD3 cannot recognize any RF handsets at all and must

be matched to the RF handset(s) by the end-user/bed manufacturer before

these can control the TD3 operation.

Conditions which must be fulﬁ lled prior to activating the learning mode:

• Both the back and the leg actuators must be in the fully down position;

if one or both actuators are NOT in the fully down position; the matching

procedure cannot be continued as now an ordinary reset down function

is performed instead. Thereafter the reset key must be released and re-

activated.

Activating the learning mode:

• Activate the reset key on the TD3 by using a pen or similar to keep the

button pressed.

• Keeping the reset key activated; the RF handset(s) must be activated one

at a time by pressing a random key on the RF handset. The RF handset ID’s

are stored in the TD3 memory and at the same time, previous RF handset

ID’s are erased.

Disturb of RF signals:

Please be aware that other equipments (as e.g. doorbells) which use

the 433 MHz can disturb the RF signal.

Under some circumstances it isn’t possible to run 2 or more TD3 at the

same time (RF signal gets disturbed).

HB12

HB20