User's Manual

5
Safety instructions
Important information
Important information on LINAK
®
products can be found under the
following headings:
Warning!
Failure to comply with these instructions may result in accidents
involving serious personal injury.
Failing to follow these instructions can result in the product being
damaged or being ruined.
Safe use of the system is possible only when the operating instructions are
read completely and the instructions contained are strictly observed.
Failure to comply with instructions marked with the ”NOTE” symbol may
result in serious damage to the system or one of its components.
Persons who do not have the necessary experience or knowledge of the
product/products must not use the product/products. Besides, persons with
reduced physical or mental abilities must not use the product/products,
unless they are under surveillance or they have been thoroughly instructed
in the use of the apparatus by a person who is responsible for the safety of
these persons.
Moreover, children must be under surveillance to ensure that they do not
play with the product.
It is important for everyone who is to connect, install or use the systems
to have the necessary information and access to this User Manual.
If there is visible damage on the product it must not be installed
Before installation, de-installation or troubleshooting:
• Stop the TD3.
• Switch off the power supply and pull out the mains plug.
• Relieve the TD3 of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User
Manual.
• Make sure that the voltage is correct before the system is connected to
the mains. (See TD3 label on page 10).
• System connection. The individual parts must be connected before
connection to the mains.