Users Manual

Page 185 of 264

3. BA19 Lead acid (MEDLINE

CARELINE

)

The BA19 lead acid backup battery has been developed speciﬁcally for

use with the new control boxes CA30/CA40 and CO61. It is a compact

and cost-efﬁcient battery with built-in charger and cable management.

Usage:

• Compatibility: Battery backup for CA/CO control box platform

• Duty cycle: 10%, 2 minutes continuous use followed by 18 minutes not in use

• Charging: Via integrated charger

• Charging time: Approx. 6 hours

• Recharging during storage: Battery recharging no later than 6 months after production date stated on the label

• Operating temperature: + 5 °C to + 40 °C

• Storage temperature: - 5 °C to + 40 °C

The batteries must be stored in an applicable storage room to avoid direct sunlight

• Relative humidity: 20% to 80% - non-condensing

• Atmospheric pressure: 700 to 1060 hPa (3000 m)

• Height above sea level: Max. 3000 meters

• Service: Battery cells cannot be replaced as the battery cover cannot be closed properly afterwards

• Approvals (pending): IEC60601-1:2005 3

edition,

ANSI/AAMI ES60601-1: 2005, 3

edition

CAN/CSA-22.2 No. 60601-1:2008

LED functionality:

What does the LED indicate?

Buzzer functionality:

The buzzer will make a warning when a button on the hand control is pressed and the battery capacity is low.

The buzzer can also be activated by the control box to signal other conditions. This must be speciﬁed in the control box software.

LED Indication of operation

Solid orange Charging (battery not ready)

No LED light Fully charged (battery ready)

Flashing yellow Error during charging

Mounting bracket (frame ﬂat) - article no. 1015W1001: Mounting instructions:

BA19 must be mounted with attachment

screw and mounting bracket (see below)

due to the battery weight.

Screw M4 countersunk torque

1.1 Nm +/- 0.1 Nm.

d M4

8.4

k 2.7

According to ISO 2009

45°