Users Manual

Page 172 of 264
The control boxes CBJ1 and CBJ2 are part of the battery driven JUMBO system. JUMBO is a modular system combining an actuator, a control box (CBJ1,
CBJ2), a battery (BAJ1) and a charger (CHJ2) in a flexible solution, specially developed for patient lifts.
The complete system is medically approved and contains a series of features which meet the patients need for a safe and comfortable lift, e.g. CBJ1 and
CBJ2 are equipped with a soft-start/stop function, emergency lowering function etc.
CBJ1 and CBJ2 are available in a special edition that can be used in the harsh conditions in the pool environment both outdoor and indoor.
Usage:
• CBJ1/CBJ2 with internal charger: Nominal current draw max. 400 mA
Power consumption (standby) max. 2.5 W
Power consumption (charging) max. 19 W
• Duty cycle: max. 10 % or 2 min. continuous use then 18 min. without use
• Ambient temperature: +5 °C to +40 °C
• Storage temperature: -10 °C to +50 °C
• Relative humidity: 20% to 80% - non-condensing
• Height above sea level: Max. 3000 meters
• Approvals: IEC60601-1, ANSI/AAMI ES60601, CAN/CSA-22.2 No 60601-1
• For one or two actuators (lift and leg spreader actuator)
3. CBJ1/CBJ2 (MEDLINE
®
CARELINE
®
)
Warning
• In order to avoid injury, the emergency-stop should be activated in (all) transport and cleaning situations.
• BAJ Li-Ion batteries differ from BAJ1 lead acid as they have built-in discharge protection.
If the user continues to use the battery despite warning signals, loss of power might happen due to the battery deep discharge protection. In this
event, there may be no warning and the application may not be ableto move when expected.
• The combination of CBJ1 or CBJ2 with BAJL might not be able to complete a full cycle after low battery warning.
Recommendations
• The mains cable must always be ordered separately when ordering a CBJ1, CBJ2 with an internal charger.
• Use only original LINAK mains cables to ensure proper connection to internal charger.
• When charging, the CBJ1, CBJ2 will not be able to operate any actuators.
• By use of charger CH01 it is possible to activate the actuators when charging. However, this is not recommended as it can damage the control box
or the charger CH01.
• When the CBJ1, CBJ2 with LCD display option is combined with the battery BAJ Li-Ion, the LCD display can indicate empty battery even if the
battery capacity is not low. The acoustic alarm will always be activated at low battery capacity independent of display indication.