Manualshelf

User's Manual

ManualsBrandsLINAK ManualsElectronicsRemote control for Actuator system
21222324252627282930
Page 26 of 44
HB22RF2001 in general:
• For light/DC/USB and massage to function on the TD33, the TD3 must be configured. By default the TD33
will not operate massage.
• Massage will turn off automatically 10 minutes after the last adjustment of the settings. This timing can be
changed in the TD3 configurator.
• Adjusting the bed or turning on/off the accessories is possible without any interruption.
• When pushing on the on/off button the massage motors will run in Continuous Mode. When pushing the
Mode button the massage mode will change.
• Turning on a single massage motor can also be done by pushing the right button for massage.
On/off (start/stop of the massage)
Mode (change between the different massage programs)
Controlling the backrest massage motor:
Keep the left button pressed to adjust the intensity down and the right button pressed
to adjust the intensity up. A short press on the right button turns on the massage motor
at current intensity. The massage will run in continues mode while being adjusted.
NOTE: The up/down intensity adjustment is reversed compared to the
HB22RF2000
Controlling the leg rest massage motor
Keep the left button pressed to adjust the intensity down and the right button pressed
to adjust the intensity up. A short press on the right button turns on the massage motor
at current intensity. The massage will run in continues mode while being adjusted.
NOTE: The up/down intensity adjustment is reversed compared to the
HB22RF2000
Store and recall settings
To store the current active massage settings, press the “S” button followed by either the
“1” or “2” button. To recall a previous stored setting, press the “1” or “2” button.
NOTE: By default the memory buttons only store the position of the TD3 back/
leg adjustment motors. Position and massage can be stored by activating this
option in the TD3 configurator.
Accessories for the TD3
Toggles on/off the light, DC or USB unit. Which function it controls is determined by the
TD3 configured via the configurator.
Massage systems controlled by HB22RF2001