User's Manual

Page 8 of 44
Before installation, de-installation or troubleshooting:
• Stop the TD3.
• Switch off the power supply and pull out the mains plug.
• Relieve the TD3 of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User
Manual.
• Make sure that the voltage is correct before the system is connected to
the mains. (See TD3 label in the appendix).
• System connection. The individual parts must be connected before
connecting to the mains.
During operation
• If the control box makes unusual noise or smells, switch off the mains
voltage immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
• The products must only be used in an environment, that corresponds to
their IP protection.
Misc:
The actuator system has a sound level below 55dB(A) in typical
applications.
Updated manuals and declarations can always be found here:
www.linak.com/HOMELINE
Electromagnetic fields (EMF):
This LINAK appliance complies will all standards regarding electromagnetic fields (EMF). If handled properly
and according to instructions in this user manual, the appliance is safe to use based on scientific evidence
available today.