User's Manual

Page 12 of 44

• Current cut-os should not be used as stop function! This might damage the actuator. Current cut-os

should only be used in emergencies!

• Current cut-o limits are not proportional with the load curves of the actuator. This means that the cur-

rent cut-os cannot be used as load indicator.

• There are tolerances on the spindle, nut, gear wheels etc. and these tolerances will have an inuence on

the current consumption for the specic actuator.

Analogue output or digital input

Orange Features available:

- Analogue feedback (+)

- Predened position 1

- Run condition

Light blue Features available:

- Analogue feedback (-)

- Predened position 2

Fixed wires

Violet Parallel communication

Violet wires must be connected together

The parallel drive function will support up to 8

actuators running simultaneously.

It is possible to run parallel with a single power

supply or run each actuator with separate

power supplies.

Please note: they must have the same potential

and the power supply GND must be connected

together (blue wires).

White Service interface The white wire is reserved for a service inter-

face (USB to PC) and has no functionality

during operation.

Grey Bluetooth

antenna The grey wire is used to strenghten the Blue-

tooth signal, allowing a stable wireless connec-

tion and has no functionality during operation.