User's Manual

Page 27 of 44
© 2020 LINAK A/S
Maintenance
• The actuator must be cleaned at regular intervals to remove dust and dirt and inspected for mechanical damages or wear.
• Inspect attachment points, wires, piston rod, cabinet, and plug, as well as check that the actuator functions correctly.
• To ensure that the pregreased inner tube remains lubricated, the actuator must only be washed down when the piston rod is fully retracted.
• The actuator is a closed unit and therefore requires no internal maintenance.
• In order to maintain a proper performance of the spherical eyes and to increase the resistance against environmental wear, we strongly recommend that the
spherical eyes (ball bearings) mounted on actuators from LINAK are greased with anticorrosive grease or similar.
Repair
Only an authorised LINAK
®
service centre should repair LINAK actuator systems. Systems to be repaired under warranty must be sent to an authorised LINAK service
centre.
In order to avoid the risk of malfunction, all actuator repairs must only be carried out by an authorised LINAK Service shop or repairer, as special tools and parts must
be used.
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date.
Main groups of disposal
LINAK’s products may be disposed of, possibly by dividing them into different waste groups for recycling or combustion.
We recommend that our product is disassembled as much as possible at the disposal and that you try to recycle it.
Warranty
There is an 18 months’ warranty on TECHLINE products against manufacturing faults calculated from the production date of the individual products (see label). LINAK’s warranty is
only valid in so far as the equipment has been used and maintained correctly and has not been tampered with. Furthermore, the actuator must not be exposed to violent treatment.
In the event of this, the warranty will be ineffective/invalid. For further details, please see standard terms of sale and delivery for LINAK A/S.
Note:
Only an authorised LINAK
®
service centre should repair LINAK actuator systems. Systems to be repaired under warranty must be sent to an authorised LINAK service
centre.
In order to avoid the risk of malfunction, all actuator repairs must only be carried out by an authorised LINAK Service shop or repairer, as special tools and parts must
be used.
If a system is opened by unauthorised personel there is a risk that it may malfunction at a later date.
The actuator is not to be opened by unauthorised personnel. In case the actuator is opened, the warranty will be invalid.
Chapter 5
Product Metal scrap Cable scrap Electronic scrap Plastic recycling or combustion
LA36 X X X X