Instruction Manual

6.2 Energy Saving tips
This rangehood operates very efficiently and economically.
The following will help you to save even more energy when
using it:
Ensure that there is sufficient ventilation in the kitchen
when cooking. In extraction mode, if there is insufficient
air flow the rangehood cannot operate efficiently and this
causes increased operating noise levels.
Always cook with the lowest possible setting. This
produces fewer cooking vapors, so you can use a lower
rangehood power level and therefore benefit from
reduced energy consumption.
Check the power level selected on the rangehood. A
lower power level is generally sufficient for the majority of
cooking. Only use the Booster setting when necessary.
When a large volume of cooking vapors is being
produced, switch to a high-power level in good time.
This is more efficient than operating the rangehood
for longer to try to capture cooking vapors which have
already been distributed throughout the kitchen.
Make sure that you switch the rangehood off after use.
Clean or change the filters at regular intervals. Heavily
soiled filters reduce performance, increase the risk of
fire and are unhygienic.
9
Problem Possible Cause Possible Solution
The light turns on but
the motor does not
work
The motor is switched off. Switch on the motor with the SPEED button.
The motor switch is broken. Contact a specialist company.
The motor is broken. Contact a specialist company.
Lights and engine
do not work.
Your mains security fuse is
flipped or broken.
Flip the fuse switch or replace the fuse.
The power cable is loose or
not connected.
Connect the power cord correctly.
The light does not
work.
The light is broken.
One way valve and outlet are
not tightly sealed.
Leakage from the connection
of chimney and cover
Replace the bulb.
Unsatisfactory suction
performance.
Oil leakage
The rangehood has
switch off during
operation.
The distance between the
cooker and the rangehood
is too far.
Reduce the distance.
Check that the fan speed is set high enough for the task
Clean the grease filter.
Turn off the hob and wait for the device to reset.
7. TROUBLESHOOTING
Check to see if the kitchen is adequately vented to allow
the entry of fesh air.
If set up for recirculation, check that the charcoal filter
is still effective.
(recommended to be replaced every 2-3months)
If set up for extraction, check that the ducting and
outlets are not blocked.
Take down the one way valve and seal with sealant.
Take chimney down and seal.
Fix the distance. If the distance is not appropriate, the
motor will cut out frequently which will damage the hood.
The safety cut-out device
has been tripped off.
WARNING
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service center if in any
doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit.
If you have completed all of the above checks and is still experiencing difficulty,
please contact your local Linärie Service Center (see the “Warranty and Spare Parts” sections).
Observe all safety and warning information during operation. ( see the General Safety Instructions” section)