Installation and maintenance guide Automatic air grease gun Model 1162 Date of issue Form number April 2016 404628B Read manual prior to installation or use of this product. Keep manual nearby for future reference.
Safety Table of contents Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Personal Safety. . . . . . . . . . . . . . . . . . . . 3 Description. . . . . . . . . . . . . . . . . . . . . . . 3 Appropriate Use . . . . . . . . . . . . . . . . . . . 5 Specifications . . . . . . . . . . . . . . . . . . . . . 5 Work Area. . . . . . . . . . . . . . . . . . . . . . . . . 5 Inspection . . . . . . . . . . . . . . . . . . . . . . . . 4 Operation. . . . . . . . . . . . . . . . . . . . . . .
Read and carefully observe these operating instructions before unpacking and operating the air grease gun. The gun must be operated, maintained and repaired exclusively by a person familiar with the operation instructions. Operate the gun only after safety instructions and this operation manual are fully understood. W ar n i n g Extreme pressure may cause whip hose to burst. Use only Lincoln approved hoses and follow the hose instructions and warnings.
Fig. 1 13 7 3 B 13 7 A 3 B A 8 12 G 8 C D 7 Fig.
Appropriate use • The air gun was exclusively designed to pump and dispense lubricant using pneumatic power. • The maximum specification rating should not be exceeded. • Any other use not in accordance with instruction will result in loss of claim for warranty or liability. Work area Specifications Pump ratio (max) Output per stroke Pneumatic inlet pressure (minimum) 40:1 0.
To fill the gun from bulk container 1 Remove head and plunger assembly from container tube. 2 Pack lubricant into cavity of the head and plunger assembly. 3 Insert the open end of the container tube into lubricant. Pull the follower handle back while pushing the container tube deeper into the lubricant to prevent air pockets from being pulled into the container tube. 4 When the follower rod is fully extended, pull it sideways to latch the rod groove into the keyhole slot in the container cap.
Fig.
Service parts No. Part no. Description Include Qty. 1 1230 Hose, 30 in. (762 mm) Hose, 30 in.
Troubleshooting Conditions Possible cause Corrective action The gun doesn’t operate. No inlet air pressure. Connect air supply. The piston (7) is stuck. Disassemble the gun, inspect for damage. Replace if necessary. Air pressure is too low. Check air pressure supply. The pressure is to be higher 40 psi. Broken return spring (12). Replace if necessary. Air pressure is too low. Check air pressure supply. The pressure is to be higher 40 psi. The piston (7) is stuck.
Lincoln industrial standard warranty Standard limited warranty Lincoln warrants the equipment manufactured and supplied by Lincoln to be free from defects in material and workmanship for a period of one (1) year following the date of purchase, excluding there from any special, extended, or limited warranty published by Lincoln. If equipment is determined to be defective during this warranty period, it will be repaired or replaced, within Lincoln’s sole discretion, without charge.
This page left intentionally blank 11
® SKF is a registered trademark of the SKF Group. ® Lincoln is a registered trademark of Lincoln Industrial Corp. © SKF Group 2016 The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted.
