User guide

A-5
INSTALLATION
VRTEX
®
360
A-5
10. Remove the four screws from the wooden rear
cross brace.
11. Remove the wooden cross brace while ensuring
the unit is steady and secure.
12. Carefully roll the machine off the rear of the skid.
Ramping may be required.
13. Uncrate and unpack the table and table base.
3/8” BOLTS
REMOVE
FRONT PANELS
STEP (2)
DO NOT
REMOVE
REAR PANEL
FRONT
(upper)
FRONT
(lower)
9. Using the 3/8” wrench, remove the two screws from
the rear base securing the unit to the wooden crate.
7. Carefully cut and remove plastic wrapping.
8. Remove the monitor from the front of the machine.
4. Carefully slide the crate assembly from the
VRTEX
®
360.
5. Slide towards the rear of the machine. Be careful to
avoid damaging the welding device holders located
on each side of the machine.
6. Carefully remove the post (long cylinder-shaped
cardboard) from the crate.
3. Remove the six 3/8” bolts (three on each side) from
the bottom of the crate assembly.
2. Using the 3/8” (9.5 mm) wrench, remove the screws
from the upper and lower front panels on the ship-
ping crate.
NOTE: Do not remove rear panel.