Manual


"'( (#"
*&(,
J
!# 

 !(
 '. )'(!"( HEADGEAR TIGHT-
NESSisadjustedbypushingintheRatchetKnoband
turningtoadjustforthedesiredheadsize.Thisknob
is located at the back of the helmet.  &
&#+")'(!"( ismadebyadjustingforcom-
fortandsnappingthepinintotheholetolocksecurely
inplace.
( ( Tiltadjustmentislocatedonrightsideofhelmet.
Loosentherightheadgeartensionknobandpushthe
top end of the adjustment lever outward until the
lever’s Stop Tab clears the notches. Then rotate the
lever forward or backto the desired tiltposition. The
Stop will automatically engage again when released
lockingthehelmetintoposition.
#&  ( )'(!"( Adjusts the distance
betweentheuser’sfaceandlens.Fore/Aftadjustment
hasbeenpre-setatthefactory.Toadjust,loosenthe
outside tension knobs and slide forward or back to
desiredpositionandretighten.NOTE:Makesureboth
sidesareequallypositionedforproperoperation.
 !( "''
The helmet has an FMD (Face MountedDisplay) on
theinside.TheseFMDlensesdisplaythevirtualenvi-
ronmenttotheuser.Eachlenscanbeshiftedleftor
right to align with the users eyes by applying gentle
pressure.Inaddition,thelensescanbeliftedupand
downaswellasshiftedforwardandbackforthebest
fit.Theusershouldmakesurethelensesareparallel
totheireyes.Keepthelensescleanatalltimes.See
CleaningandMaintenance Section D.
"#( *Condensation on lensesmay appear in high
humidity environment. Run FMD for approxi-
mately 10 minutes to clear up moisture from
thelenses.
)&M  !()'(!"('
Push In
Tilt
Adjustment
Crown
Adjustment
Fore-Aft
Adjustment
Lenses
Tilt
Ratchet Knob
)&M  !( "''
"''