Manual



#$&(#")'&!#



("%)$&!(&'

Theupperleftareaofthescreenshowsthetechniqueparametersbeingtrackedandthegraphoftheseparame-

tersislocatedtotheright.SeeFigureB.41.Whentheuserwelds,eachparameterisgraphedusingalinethat

isofthesamecolorasthetechniqueparameterbox.Forexample,“position”iswrittenintheblueboxandindi-

catedbytheblueline.Theleftsideofthegraphrepresentstheleftsideofthecoupon,andtherightsiderepre-

sentstherightsideofthecoupon.Forverticalwelds,thegraphisrotatedsothatitisvertical,withthebottomrep-

resentingthebottomofthecouponandthetoprepresentingthetopofthecoupon.Thegraphalsoshowshow

closetheparameterwastotheidealvalue.Theidealvalueisindicatedbytheredlinelocatedinthecenterofthe

graph.Thisvalueisdeterminedbythetoleranceeditorsettings.Theupperandlowerwhitelinesrepresentthe

acceptablemaximumandminimumvaluesthattheparametershouldbewithin.Thesevaluesarealsodetermined

bythetoleranceeditorsetting.Anythingabovethetopwhitelineorbelowthebottomwhitelineisoutoftolerance.

Theclosertheuseristotheidealline,thebettertheweld.Eachparametercanbetoggledonoroffofthegraph

bytouchingtheappropriateicon.

*&(,

!# 

)&M '&'&"&$(''#"(")('(